How do I replace a slide pin ratchet on the ratcheting square drive wrenches?
The ratchets used by S/R are designed for simplicity of maintenance, as well as strength and durability. We make Ratchet Renewal Kits in four sizes to permit those whose ratchets have become worn or damaged to renew the ratchet and extend the working life of the tool. The procedure has three sections: removal of worn components, cleaning, and lubrication and installation of the new components. Each step of this procedure is written, and shown with a small image. To see a large version of the image, simply click on the picture. This will display a larger and clearer version. Use your browser's back button to return to the procedure. Needed Items:
|
|
 |
Check for correct Ratchet Renewal Kit. |
|
Remove snap ring. |
 |
Remove square drive. Lift straight out. |
|
Remove slide pin and ball. Use caution - ball is under slide pin and spring loaded. |
 |
Remove spring. |
 |
Clean head. Remove dirt and grease. |
 |
Open renewal kit. |
 |
Use molybdenum disulfide high pressure grease to lubricate parts. |
 |
Lube inside of head very lightly. |
 |
Insert spring. |
 |
Insert ball. Ball sits on top of spring. |
 |
Lightly lube bottom of slide pin. |
|
Insert slide pin. Slide pin goes over ball and compresses spring. Slide pin should slide to two positions easily. |
 |
Lube square drive ratchet teeth. |
|
Insert square drive ratchet in head. |
 |
Lube one side of washer lightly. |
 |
Insert washer with lubricated side towards ratchet. |
|
Insert snap ring. |
 |
Reassembly is complete when snap ring is installed. |
